Related Manuals for Brave MVH1334C
Summary of Contents for Brave MVH1334C
- Page 1 MVH1334C Model: VH1334VN VH1334GX Brave 34 Ton Vertical / Horizontal Log Splitter Model VH1334 Owner / Operator and Safety Manual...
- Page 3 ❏ Make sure the trailer hitch of the towing vehicle is equipped with a 2 inch ball. NOTE: Brave reserves the right to make technical changes for product improvement. This manual may contain illustrations and photographs, for demonstration purposes, which slightly deviate from the actual product design.
-
Page 4: Table Of Contents
Optional Attachments ..........45 Log Cradle, Log Dislodger, and Safety Flag ......45 Brave 800-350-8739... - Page 5 If any doubt or question arises about the correct or safe method of performing anything found in this or other Brave manuals, contact your Brave dealer or call the Sales and Service representatives at our main headquarters. Proper care is your responsibility.
-
Page 6: Introduction
An attractive, powder-coated finish provides the finest protection available and Brave’s rigid, quality-control and component testing help ensure years of productive, reliable service. Since 1982, the name Brave has stood for quality and reliability when it comes to log splitters and wood processing products. -
Page 7: Worksite Safety
ALWAYS disconnect the spark plug wire when the log splitter is not in operation. ✘ Do not allow any person to operate the log splitter until they have read and understood the safe operating instructions contained in this manual. 800-350-8739 Brave... -
Page 8: Log Splitting Safety
✔ ALWAYS inspect your log splitter before each use. Make sure all nuts, bolts, screws, hydraulic fittings, hose clamps, etc. are securely tightened. Brave 800-350-8739... -
Page 9: Towing
✘ NEVER tow your log splitter when there is fuel in the engine’s tank. ✘ NEVER allow anyone to sit or ride on your log splitter. ✘ NEVER carry any cargo or wood on your log splitter. 800-350-8739 Brave... -
Page 10: Refueling
(if any). If a spark arrester is used, it should be maintained in effective working order by the owner and/or operator. Brave 800-350-8739... -
Page 11: Assembly Instructions
Bolt (1/2-13 x 3-1/2”) Bolt (5/16-18 x 3/4”) Locknut (1/2-13) Locknut (5/16-18) Rail Latch Assembly Jack Assembly Rail Rest Weldment Jack with Wheel Bolt (1/2-13 x 1-1/2”) Mounting Straps Lockwasher (1/2”) Bolt Nut (1/2-13) Locknut On the pallet. In cardboard box. 800-350-8739 Brave... -
Page 12: Unpacking The Crate
2. Carefully check the larger components on the shipping pallet for damage. If the parts are damaged call Brave at (815) 672- 8861. 3. Cut all the remaining banding straps, open the cardboard box, and make sure all the smaller parts have been shipped. -
Page 13: Assembly Procedure
Place the two mounting straps over Front the bolts on the opposite side of the tongue Left Side (Hitch coupler end) and loosely install the locknuts. 800-350-8739 Brave... - Page 14 5. Carefully stand the rail assembly in an upright, vertical position. VH34-06b NOTE: If also installing optional BR021180 Log Cradle, assemble it at this time. The log cradle uses the first and third holes. Brave 800-350-8739...
- Page 15 NOTE: Block the wheels to prevent the base unit from moving. Securely tighten the nuts holding the base unit to the rail assembly (Step 7) and the nuts holding the rail rest assembly (Step 8). 800-350-8739 Brave...
- Page 16 12. Insert the chain link into the valve body, as shown, with the pins facing upward. 13. Position the control lever, as shown, and install it onto the chain link pin. Place the chain link side plate on top of the two pins. Brave 800-350-8739...
- Page 17 Screw the filter onto the filter head, located near the hydraulic tank. Once the filter makes contact with the filter head, turn it an additional 3/4 turn. Hand-tighten only. 800-350-8739 Brave...
- Page 18 The log splitter is now completely assembled. Follow “Start-Up Procedure,” in the following section, which adds oil to the engine and hydraulic tank before trying to start the engine. Brave 800-350-8739...
-
Page 19: Start-Up Procedure
Pull the engine starter cord (about 15 times) with the other hand, until the cylinder piston moves forward. (Keep everything away from the splitting wedge during this step). NOTE: Extending the cylinder draws the hydraulic fluid through the system and expels any trapped air in the cylinder. 800-350-8739 Brave... - Page 20 Cycle the log splitter several times. 10. Again, check the fluid level in the hydraulic tank and add oil as needed. Replace and tighten the fill cap. 11. Your log splitter is now ready to use. Brave 800-350-8739...
-
Page 21: Towing
3. Raise the front leg to the towing position by pulling the spring pin. If not already secure, make sure the hitch coupler is properly and securely attached to the tow ball. 800-350-8739 Brave... - Page 22 Failure to securely attach the log splitter can cause loss of control of the vehicle or the log splitter being separated from the towing vehicle, resulting in serious injury or death. Brave 800-350-8739...
-
Page 23: Operation
If any doubt or question arises about the correct or safe method of performing anything found in this or other Brave’ manuals, contact your Brave’ dealer or call the Sales and Service representatives at our main headquarters. Proper care is your responsibility. -
Page 24: Operation - Horizontal Position
(end plate), opposite the splitting wedge. CAUTION Do not place your hands on the ends of the log when loading the log splitter. This is a very UNSAFE method and could result in injury to your hands. Brave 800-350-8739... - Page 25 Do not operate the log splitter by reaching across the rail. Do not reach or step across the rail while the log splitter is running. This is a very UNSAFE method which could cause personal injury or even death. 800-350-8739 Brave...
- Page 26 ✔ Helps eject any log that sticks to the splitting fully retracted could lead to possible wedge. ✔ Protects control valve and other hydraulic injury and/or damage to the log splitter. components from damage. ✔ Rugged construction to last the life of your log splitter. Brave 800-350-8739...
-
Page 27: Operation - Vertical Position
Block the wheels and stand the rail assembly up into a vertical position. c. Turn the knob handle until the pin slides into the slot. This allows the plunger to snap into place, securing the rail assembly in a vertical position. 800-350-8739 Brave... - Page 28 (towards the log). If the log moves before it is contacted by the splitting wedge, release the control lever and then reposition the log. Operate the log splitter only when standing in the safe operating area, as shown in the picture. Brave 800-350-8739...
- Page 29 (stop the wedge from retracting) and carefully remove the log from the wedge. Allowing remain attached to the wedge when it is fully retracted could lead to possible injury and/or damage to the log splitter. 800-350-8739 Brave...
-
Page 30: Inspection And Maintenance
Always replace frayed, kinked, or cracked hoses and/or other damaged hydraulic components with Brave authorized parts and components specified in the “Parts” section of this manual. Replacement parts from secondary suppliers (not original Brave replacement parts) can lead to product damage and/or personal injury and will void the warranty. -
Page 31: Hydraulic Oil Change
Hydraulic Oil Change Brave recommends an oil and filter change every 100 hours of operation. Refer to the “Specifications” section, in this manual for the type and quantity of oil. Important Notice Never run the log splitter unless the hydraulic oil tank is full. - Page 32 Replace the spark plug and spark plug wire. b. Start engine cycle cylinder several times. c. Retract the cylinder and shut off the engine. d. Recheck the hydraulic tank to make sure oil is filled within one inch from the top of the tank. Brave 800-350-8739...
-
Page 33: Specifications
DO NOT mix different types of hydraulic oils and transmission fluids (e.g., synthetic with non-synthetic). Hydraulic oil is NOT compatible with transmission fluid, and different TYPES of hydraulic oils and transmission fluids MAY NOT BE compatible with each other. 800-350-8739 Brave... -
Page 34: Troubleshooting
The following section will detail procedures for checking your log splitter, should you encounter a malfunction. Brave recommends that you do not attempt to make repairs to the log splitter. In the long run, it is better to take your log splitter to a servicing lawn and garden dealer for repairs. -
Page 35: Decals
Decal, Serial Number BR002653 Decal, Maximum Speed BR002310 Warning, Crush Injury BR002311 Warning, Tow Safety BR002505 Warning, Pinch Point-Dislodger BR002559 Proper Machine Loading 39259 Warning, Carbon monoxide 777890 Warning, Fire Hazard 786635 Warning, Burn Hazard 787944 Warning, Pinch Point 800-350-8739 Brave... - Page 36 Brave 800-350-8739...
- Page 37 (10) (12) (11) (13) (14) 800-350-8739 Brave...
-
Page 38: Parts
Brave 800-350-8739... - Page 39 Forward Item Part No. Description Item Part No. Description Model Model BR02124911SO Weldment, Base Tank BR008540 Coupler, Hitch, 2” BR008301B Seal, Inside BR021251 Pin, Hinge BR008301A Bearing, Tapered Roller BR031102 Bracket, Hinge BR008301 Tire 4.8” x 8” BR001764 Clip, Hairpin, 3/32 x 2-1/2” 778844 Washer, Thrust BR021396 Pin, Plunger...
- Page 41 800-350-8739 Brave...
- Page 42 Item Part No. Description Model Note 1: Hole is used to attach optional BR021180 BR02126408SO Weldment, Rail Log Cradle. BR02139302 Weldment, Rail Rest Note 2: Hole is not used in this application. 82509 Nut, 1/2-13 82519 Lockwasher, 1/2” Note 3: Hole is used to attach optional BR021180 ...
- Page 43 800-350-8739 Brave...
- Page 44 Item Part No. Description Item Part No. Description Model Model GNEGX270 Engine, GX 270 VH1334GX 777835 Clamp, Hose, No. 16 BR003023 Engine, 10 HP VH1334VN BR004998 Hose, Low-Pressure, 1 x 9” 784168 Key, Engine Shaft VH1334VN BR004100 Valve 82515 Screw, Set, 5/16-18 BR001052 Fitting, Straight BR006001C...
-
Page 45: Warranty Card
800-350-8739 Brave... -
Page 46: Warranty
Warranty For one year from the date of purchase, Brave will replace for the original purchaser, or repair free of charge, all parts of the Brave Hydraulic Log Splitter returned to our factory PREPAID and found upon inspection by us to be faulty, due to defects in materials or workmanship. -
Page 47: Log Cradle, Log Dislodger, And Safety Flag
Important Warranty Information To activate your Brave log splitter warranty, please Brave fill out the information in the form below and mail 20195 S. Diamond Lake Rd., STE 100 in an envelope to the address listed on the right or Rogers, MN 55374 go online to www.braveproducts.com... -
Page 49: Optional Attachments
Safety Flag Kit (Part No. BR012104) ✔ Improves visibility of log splitter when backing up or towing. ✔ Heavy-duty tapered fiberglass pole won't bend over at towing speeds. ✔ Installs in minutes, no drilling required. ✔ Mounting instructions included. 800-350-8739 Brave... - Page 50 Brave 20195 S. Diamond Lk Rd., STE 100 Rogers, MN 55374 Phone: 800-350-8739 (Toll Free) Fax: 866-779-9963 E-mail: sales@braveproducts.com Website: www.braveproducts.com VH1334 9/12...