Table of Contents
Advertisement
6. Check the fluid level in the hydraulic tank and add oil as needed.
Be careful not to spill fuel when filling the engine. If fuel should spill,
quickly wipe off and allow the excess fuel to evaporate before
continuing. Fuel and fuel vapors are highly flammable and can cause
personal injury or even death when ignited.
If your log splitter is equipped with a factory installed engine, do not mix oil
with the gasoline. Using mixed oil/gasoline in a four cycle engine can cause
engine damage.
7. Fill the engine's fuel tank with fresh, clean, lead-free automotive gasoline.
8. Attach the spark plug wire and start the engine per the manufacturer's instructions.
9. With the engine running, push the valve control handle to the retract position and
retract the cylinder piston. The cylinder valve will automatically stop the cylinder from
retracting when it reaches the end of its stroke. Cycle the log splitter several times.
10. Again, check the fluid level in the hydraulic tank and add oil as needed. Replace
and tighten the fill cap.
11. Your log splitter is now ready to use.
Brave
WARNING
Important Notice
18
800-350-8739
Advertisement
Table of Contents
