Table of Contents
Advertisement
Step 7: Set the correct "Baudrate" (default value: 115200 bps).
Step 8: Click "Open Port" as shown in Figure 5 above, then the communication with EVB is successful.
At this time, the NMEA message output by the module is displayed in the receiving bar of the
QCOM tool, as shown in the figure below. For more details on QCOM usage, see document [1].
LC29D_EVB(0)_User_Guide
Figure 6: QCOM Receiving Bar Interface (Connected)
GNSS Module Series
17 / 42
Advertisement
Table of Contents
