Figure 5 Removing The Base Tray - Metrohm 942 Extension Module Vario LQH Manual

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1
942 Extension Module Vario LQH (2.942.0070)
2
Figure 5 Removing the base tray
1 Tilt the instrument sideways and lay it down flat.
2 Loosen the 4 cylinder screws with the 3 mm hex key. Remove the cyl-
inder screws and their washers.
3 Remove the base tray.
Always mount the base tray under the lowermost instrument of the stack.
Mounting the base tray
Prerequisites
The instrument is switched off.
￭
The bottle holder is cleared.
￭
All of the cable connections on the rear have been disconnected.
￭
There are no loose parts in the instrument.
￭
The instrument is lying on its side, and the bottom surface is visible.
￭
Accessories
3 mm hex key (6.2621.100)
￭
3 Installation
3
￭￭￭￭￭￭￭￭
13