Setup - Artic FUSION SPLICER 5.7 Operation Manual

Setup

The "setup" menu is used to set the data including the Brightness, Auto power off, Tension,
Language etc., as shown below.
Operation Mode
The operation mode is the method of the machine fusion, which consists of: automatic or manual
mode.
This parameter, automatically, turns off the windshield in the standby interface, the splicing machine
will begin running splice fiber optic procedures. Manual mode requires the user to press the "SET"
button, and the machine will begin splicing optical fiber. Select the menu button, and press the key
the parameter values w ill switch between "automatic" and "manual".
Suspend 1 When fiber splicing, fiber advancing to meet the gap conditions, the program pauses,
waiting for the further operation of the user. For continue to splicing, press "SET" button. To interrupt
splicing, press the "RESET" button.
Suspend 2 Fiber suspend the running at the end of the subsequent process of aligning.
Reset time After a fiber splicing, to prepare for the next splice, propulsion motors need to be reset to
the reference position. Fiber splicing completed, open the windscreen, over sometime to wait for
propulsion motors to begin to reset. The waiting is the time that automatically reset. The menu
selected, press the key or to change the parameter values.
OPERATION MANUAL OUTDOOR MULTIFUNCTION FUSION SPLICER FUSION SPLICER 5.7
PICTURE 16 PICTURE 16
FIGURE 4.4 FIGURE 4.4
17