Fiber Clamping - Artic FUSION SPLICER 5.7 Operation Manual

Fiber clamping
Open the windproof cover and the two side fiber platens, then, put the prepared fiber into
PICTURE 16
V-groove through the locating slot. Make sure that the fiber end face should be located
between the V-groove edge and two electrodes.
Shown in Figure 3.5
FIGURE 3.5
Please operate carefully and donʼt let the fiber end face touch any other object. Then close
the large platen to fix optical fiber, which should be placed horizontally in the V-groove,
without upturned phenomenon. If clamping failed, you can lift fiber carefully and repeat the
operation above until the fiber clamping is qualified.
Similarly, prepare and clamp the other optical fiber.
Then, close the windproof and continue to observe the amplified fiber from the display. If the
fiber end face is uneven, tilt or damaged, you need to remove the fiber to cut again.
12
OPERATION MANUAL OUTDOOR MULTIFUNCTION FUSION SPLICER FUSION SPLICER 5.7