Artic FUSION SPLICER 5.7 Operation Manual page 16

The "type" represent which the fiber is fused by the parameter. Abbreviations are explained in
the following.
SM: Single mode fiber
MM: Multi mode fiber
DS: Dispersion shifted fiber
NZDS: Non-zero dispersion-shifted fiber
The state ON/OFF says the group is currently used or not. Press the key or to change the
current splicing parameter group.
Press the key to enter the para group， as shown above.
The parameter consists of the following parameters:
Prefuse time In the total fusion process, a short time about 30ms in SM 16ms in MM, . It is not
recommended for the new user to modify.
Fuse time In the total fusion process, a long time 2.0 seconds in SM, 1.2 seconds in MM. It is
not recommended for the new user to modify.
Arc Discharge current means that the discharge arc current intensity. The high value of the
current corresponds to a greater arc, resulting in a higher temperature. The fiber is ablated
more seriously. Press the key or to increase or decrease the parameter value.
Pushing Overlap The pushing forward distance in fusion process. Press the key or to
add or sub the value of overlap.
Gapping The distance of fiber gap before fusing. Press the key or to change it.
Max end face The angle between the fiber end and vertical direction is the end face. In the
process of judging the fiber end face, the fiber end face should not more than the Max
end face.
State It shows them using state of the current viewing parameter group. You can press the
key or to change the parameter.
OPERATION MANUAL OUTDOOR MULTIFUNCTION FUSION SPLICER FUSION SPLICER 5.7
PICTURE 16
FIGURE 4.3
16