Artic FUSION SPLICER 5.7 Operation Manual page 29

Cleaning fiber presser foot
The dust accumulated on the fiber press foot will cause pressure instability and affect the quality of
fusion. So, it should be wiped off from the fiber pressure foot regularly. Open the windproof cover,
and then use the cotton dipped in alcohol to clean the surface of the presser foot. When cleaning,
donʼt repeat back and forth with cotton, but to wipe the foot in one direction. Besides, users need to
spin the cotton swabs, keeping the unused cotton facing the presser foot, waiting for the alcohol
volatile.
Cleaning reflector
When the reflector accumulated with dust, the fiber imaging through the reflector will fuzzy and in
incorrect position as a result of bad fusion loss, so the dust should be wiped off from the reflector
regularly.
When cleaning, with reference of the below graphic, from the center to the edge of the reflector,
user should rotate the cotton ball dipped in alcohol to clear repeatedly until the reflector is of neat
and tidy.
Cleaning objective lens
Microscope is the core component of the machine optical system. So its surface must be kept clean,
and users should regularly clean. The microscope is cleaned by the swab which dipped in a little
alcohol, with a spiral movement from the center to the edge of the lens and the rotation around the
swab until to spin out the edge of the lens.
OPERATION MANUAL OUTDOOR MULTIFUNCTION FUSION SPLICER FUSION SPLICER 5.7
FIGURE 5.3
29