Table of Contents
Advertisement
4.2. Setup
The "setup" menu is used to set the data including the Brightness, Auto power off, Tension,
Language etc., as shown below.
4.2.1. Operation mode
The operation mode is the method of machine fusion, which consists of: automatic or manual mode.
This parameter, automatically, turns off the windshield in the standby interface, the splicing machine
will begin running splice fiber optic procedures. Manual mode requires the user to press the SET button,
and the machine will begin splicing optical fiber. Select the menu button, and press the key , the
a p
a r
m
e
e t
v r
l a
e u
s
i w
s l l
w
Suspend 1 When fiber splicing, fiber advancing to meet the gap conditions, the program pauses,
waiting for the further operation of the user. Continue to splicing, press SET button. To interrupt
splicing, press the RESET button.
Suspend 2 Fiber suspend the running at the end of the subsequent process of aligning.
Reset time After a fiber splicing, to order to prepare for the next splice, propulsion motors need to be
reset to the reference position. Fiber splicing is completed, open the windscreen, over some time
to wait for propulsion motors to begin to reset. The waiting is the time that automatically reset. The
menu selected, press the key or to change the parameter values.
FIGURE 4.4
t i
h c
b
e
w t
e e
" n
u a
o t
m
a
c i t
USER MANUAL HANDHELD FTTX FUSION SPLICER FUSION SPLICER 4.3
USER MANUAL HANDHELD FTTX FUSION SPLICER FUSION SPLICER 4.3
"
n a
" d
m
n a
u
" l a
16
Advertisement
Table of Contents
