Leica mojoRTK User Manual page 49

Operation
mojoRTK Base Station Operation
1. Ensure base station setup has been completed and batteries are fully charged.
2. Push and hold the
comes on.
3. The screen will become active and begin a count down as it searches for satel-
lites. It will then go to the main menu and to find the position of the base station.
4. While the base station is calculating the position, the screen will read
wait.
5. In a few minutes from when
wait Position Fixed
to
Initial startup of the base station can take up to several minutes to acquire
due to downloading the GPS almanac. Also, startup times can be increased
after long storage periods.
6. At this time, the base station has a fixed position.
7. Now check the radio channel and ensure it is the same as the mojoRTK console.
It is suggested to start with channel 0 unless interference is detected.
If the base station can not get a GPS fix in two minutes it may enter a quiet mode
where the system will appear to shut down and restart. This can happen a maximum
of three times.
power button
is pushed, the screen will go from
.
mojoRTK
for two or three seconds until the screen
fixing...pls
fixing...pls
49