Leica mojoRTK User Manual page 121

Normal System Operation
Configuring NMEA Output, step-by-step
1. Switch on the mojoRTK console and from the Navigation screen press
enter the main menu.
2. Use the main dial to select Settings -> Extended Features -> NMEA settings.
3. Select Output Enabled to turn NMEA output on, and then press
4. Select Baud Rate to change the RS232 baud rate, and then press
main dial to scroll through the list of baud rates. Press
to cancel.
5. To change the output rate of a sentence select the desired sentence from the
menu, and then press
10 Hz or 20 Hz. Press
Not all sentences support output rates greater than 1 Hz.
. Use the main dial to select either Off, 1 Hz, 5 Hz,
to select a rate or
mojoRTK
.
. Use the
to select a rate or
to cancel.
to
121