Data Transmission - RADEMACHER Fernotron Programming Centre Operating Instructions Manual

Data transmission

Recommendation
Automatic data
transmission after
every setting
Buttons
1.
2.
M
3.
/
OK
4.
/
or
/
38
We recommend performing the data transmission procedure in
one go after completing all settings. This saves a lot of time,
particularly when carrying out extensive settings or when several
Fernotron receivers are involved
If necessary, you can activate the automatic data transmission in
expert mode (see page 55, pt. 20, factory setting = OFF). You
will then be requested in the display to transmit data after every
setting.
In this case you can start the data transmission right from point 6.
Indication in the display
Perform desired settings
Call up the menu
Select and open data
transmission (
Select group and/or receiver
for data transmission
Select the receiver whose settings
/
you previously altered with the
Programming Centre.
Select group/receiver numbers.
/
)