RADEMACHER Fernotron Programming Centre Operating Instructions Manual page 48

Overview of all functions and parameters in expert mode
No. Function/Display
4 Enter radio code for a
Fernotron radio-con-
trolled tubular motor
48
Parameter/Brief explanation
ADVICE
Only for Fernotron radio-controlled
tubular motors manufactured by
Rademacher which have a radio
code sticker on the cable.
Set the radio code.
/
Alter the flashing figure
Confirm each figure
OK
As soon as you have confirmed the
last figure the menu „Radio code"
will appear again.
IMPORTANT
After entering the radio code you
have direct contact with the radio-
controlled tubular motor.
You can immediately call up and
set the following functions without
entering a group or receiver num-
ber.
SET function
Register the Programming Cen-
tre with the receiver (radio-
controlled tubular motor), (see
page 40).
Direction of rotation
Direct setting of the angle of
rotation.
End positions
Direct setting of the end po-
sitions.
ADVICE
On the following page we will
describe an example of how to
directly set the direction of rotation
of a radio-controlled tubular motor.