Important Advice Before Adjusting The Settings - RADEMACHER Fernotron Programming Centre Operating Instructions Manual

Important advice before adjusting the settings

i
Settings
Initial operation
10
Two situations can be distinguished in which you adjust settings:
Initial operation/installation of a Fernotron system for the
first time.
Subsequent changes/settings made to an existing Fernotron
system.
Please proceed as follows:
1
Preliminary thoughts:
Fill in the table on page 14 with the allocation of the receivers
(including the names and number) and the desired settings.
Please refer to page 13 for a table of the names
ADVICE
suggested and preset by the manufacturer.
2
Call up and carry out the commissioning assistant (see page 17)
Basic settings via menu navigation with standard switching times
including allocation of the names and numbers of the groups
and receivers.
This will make you familiar with the setting principle.
ADVICE
3
Other settings enabling individual adaptation
Setting the weekly timer
Activating and setting the automatic sunlight protection mode
etc.
4
Registration of the Programming Centre and data transmission
To enable your settings or manual switching commands
to become active you must first register the Programming
Centre once with each Fernotron receiver (see page 40).
The allocation and all settings (including the time etc.) will
also be transmitted to each individual receiver at the same
time.