Basic Principle Of Menu Navigation - RADEMACHER Fernotron Programming Centre Operating Instructions Manual

Basic principle of menu navigation

M
Subsequent alteration
of settings
All the functions are
listed in the menu
1.
2.
3.
4.
5.
6.
7.
8.
In this case we assume an existing Fernotron system in which the
Programming Centre has been registered with all receivers, as
described in the initial operation procedure.
You can call up the menu any time in order to select and set
individual functions according to your wishes.
Call up menu
M
Select functionIf a function is selected then the corresponding
/
symbol will flash
Confirm the functionThe setting mode is activated, and the
OK
value to be set flashes
Select the group and/or receiver whose settings are to be
/
altered
Alter the values in setting mode
/
Confirm the setting and return to the menu
OK
Quit the menu
M
The moving text „Data transmission" will appear automatically
at the top of the display.
ADVICE
If the automatic data transmission was activated in expert mode
(see page 55, point 20, factory setting = OFF), you will be
requested to transmit data at this point (see page 38).
21