Activating And Deactivating Automatic Operation - RADEMACHER Fernotron Programming Centre Operating Instructions Manual

Activating/deactivating automatic operation for a group
Buttons
1.
/
2.
OK
Press for
approx.
1 sec.
24
Indication in the display
Select the desired group
Then press the E button several
times until an A appears in the
lower right-hand side of the display
(A = all receivers).
Notice the display:
If the various receivers in the group
have different settings, the AUTO
and the MANU indication will
appear in the display.
Activating and deactivating
automatic operation
AUTO = Automatic operation on
MANU = Automatic oper. off
ATTENTION
If the receivers have different
settings, then first of all receivers will
changed to AUTO.
ADVICE
If the automatic data transmission
was activated in expert mode (see
page 55, point 20, factory setting
= OFF), then you will be requested
to transmit data at this point (see
page 38).