Avaya Aura Communication Manager Branch i120 Installation, Quick Start page 6

One mounting bracket with cable holder
Jumper for NVRAM init.
Mount
Using your Communication Manager Branch i120 on a table
To use the Communication Manager Branch i120 on a tabletop, you must attach the provided
rubber feet to the underside of the Communication Manager Branch i120.
1. Remove the four rubber feet from the packaging.
2. Turn the Communication Manager Branch i120 upside down.
Note:
Ensure the base of the Communication Manager Branch i120 is clean.
Note:
3. Peel the feet off the backing sheet.
4. Position each foot into one of the mounting sites, near each corner of the Communication
Manager Branch i120.
5. Press each foot firmly so that it adheres strongly to the Communication Manager Branch
i120.
Mounting your Communication Manager Branch i120 in a rack
You can mount the Communication Manager Branch i120 in a standard 19-inch rack.
4 Communication Manager Branch i120 Installation Quick Start