Advertisement
Figure 5: Inserting the additional screws
7. Verify that the Communication Manager Branch i120 is level and horizontal.
8. Tighten the mounting screws. Do not overtighten.
9. Either tighten the two bottom-most screws that you inserted in step 2 or remove these
screws completely.
10. Verify that the ventilation slots are unobstructed.
Mounting yourCommunication Manager Branch i120 on a wall
To mount the Communication Manager Branch i120 on a wall, use the two mounting brackets
without cable guides. You can also add a mounting bracket with cable guides if desired (see
Figure 1: Attaching the cable guide
!
CAUTION:
If you are in the installing the Communication Manager Branch i120 in the United
CAUTION:
States of America:
The AC power supply cord must not be attached to the building wall, for example with
●
wire staples, clamps, and so on.
You must install the Communication Manager Branch i120 near the AC receptacle
●
(socket outlet) that will service the Communication Manager Branch i120.
You must install the AC power supply cord in a manner that minimizes the risk of
●
physical damage to the cord. The cord should not be hanging on the floor, or routed in
any manner that would subject it to physical abuse.
8 Communication Manager Branch i120 Installation Quick Start
on page 6).
Advertisement
