Sd Section P In P Effects - Edirol V-440HD Owner's Manual

Changing the Switching Method
The V-440HD allows you to use the "flip-flop" switching method,
the one employed by many professional-level video switchers.
Use the following procedure to change the switching method.
1.
Press the MENU button.
2.
Select "13. System."
3.
Press the ENTER button.
4.
Select "14. Panel Operation Mode."
5.
Press the ENTER button.
6.
Select "PGM-PST Mode."
The "A/B Mode" is also referred to as the "butterfly" method.
When "PGM/PST" is selected, then even if "Change" is selected
as the "operational mode to be used when you press the AUTO
button" (p. 37), operation will in fact be the same as if
"Continue" were selected.
Flip-Flop Operational Method
A-BUS Channel Buttons (SD) (p. 38)
These select the PGM output from the SD section.
B-BUS Channel Buttons (SD) (p. 38)
These select the Preview output from the SD section.
* This may be referred to as the "preset" with other manufacturer's
equipment.
AUTO Button (SD) (p. 37)
This switches the video selected with the A-BUS and B-BUS
channel buttons.
* This performs the same function as the "TAKE" button on other
manufacturer's devices.
* When a wipe switch is selected, the wipe is fixed in one direction.
Video Fader (SD) (p. 37)
This switches the video selected with the A-BUS and B-BUS
channel buttons, regardless of the direction in which the fader is
tilted.
* When a wipe switch is selected, the wipe is fixed in one direction.
P in P PATTERN Button (SD) (p. 39)
This places the video selected with the B-BUS channel buttons
in the sub screen, regardless of the direction in which the fader
is tilted.
KEY ON Button (SD) (p. 41)
This applies key composite effects to the video selected with the
B-BUS channel buttons, regardless of the direction in which the
fader is tilted.
SD Section Operations

SD Section P in P Effects

P in P (Picture in Picture) effects are applied to the video on the
A-BUS or B-BUS. The P in P effect is used just by pressing the P in P
PATTERN buttons (SD).
Background Insert
Procedure for Setting the SD Section P in P Effect
1 3 2, 4
1.
Select the video to include in the sub-screen with the A-
BUS channel buttons (SD) (or B-BUS channel buttons (SD)).
2.
Tilt the video fader (SD) to the opposite side from that of the
bus selected in Step 1.
3.
Press a P in P PATTERN button (SD).
The button or buttons pressed in Step 1 flash. At this point, a
button flashing indicates that the P in P effect is being applied to
the video assigned to that button.
Button Sub-Screen Position (Factory Setting)
Upper left
1
Upper right
2
Lower right
3
Lower left
4
Center
5
4.
Tilt the video fader (SD) to the opposite direction.
The video assigned to the channels corresponding to the
flashing buttons in Step 3 appears as the sub-screen.
* When using the P in P effect while a key composite effect is in use, the
P in P is applied to the video with the key effect settings included.
* Use of the A-BUS channel buttons (SD) (or B-BUS channel buttons
(SD)) while combining video with the P in P effect may result in
disruption of the video image.
* Wipe Patterns 1–6 cannot be selected with the "TRANSITION
buttons (SD)" (p. 38) while the P in P effect is in use.
39