Setting The Sd Input - Edirol V-440HD Owner's Manual

Fixed Aspect: Crop
When "Fixed Aspect: Crop" is selected, the aspect ratio of the input
video is maintained, and the images are sized to fit within the screen
(refer to figure below). However, if the aspect ratio of the input
video differs from the output aspect ratio, a portion of the video
image is cropped, and the cropped portion is not displayed.
Input
4:3
NTSC / 480i
PAL / 576i
1024 x 768
800 x 600
640 x 480
4:3 (Letterbox)
NTSC / 480i
PAL / 576i
4:3 (Squeeze)
NTSC / 480i
PAL / 576i
16:9
1080i
720p
Manual
In cases where you are unable to achieve the optimal aspect ratio
using either "Full Scale," "Fixed Aspect: Letter," or "Fixed Aspect:
Crop," use "Manual" in "5. Scaling Type" to adjust the aspect ratio
manually. After selecting "Manual" with the procedure described on
p. 28, press the MENU button and adjust the horizontal and vertical
dimensions with "6. Manual X Scale" and "7. Manual Y Scale" and
adjust the position with the "8. X Position" and "9. Y Position"
settings.

Setting the SD Input

Although the SD input is in a fixed format, there may be differences
in the type of device used or physical differences, and it may be
necessary to set each input individually.
Output
Settings
Make the SD video settings in the menu with "7. SD Input." In "7. SD
Input," you can select from the SD Channel 1–4, and make settings
the parameters listed below.
* For more on the menus, refer to "Menu Operations" (p. 25).
* To quickly go to the Input settings menu, hold down the MENU
7. SD Input Settings Parameters
SD InputSelect
SD Brightness
SD Contrast
SD Saturation
SD Hue
SD Sw Enable
SD Reset
About SD Input
The V-440HD is compatible with the following SD signal formats.
• NTSC
• PAL
Inputting Analog Component SD Video
To input SD video to the V-440HD as analog component video,
input to the HD/RGB IN BNC connectors. In this case, the input
SD video is handled in the HD/RGB section.
With analog component input, no interlace to progressive
conversion is performed. We recommend that a progressive
signal (480p/576p) be employed for the SD video input.
Input and Output Settings
button and press any of the SD IN buttons 1–4.
Selects S-Video or composite for the SD input
Brightness adjustment
Contrast adjustment
Saturation adjustment
Hue adjustment
Selects Enable or Disable for the selected channel
button
Resets the above settings to the original factory
settings
59.94 Hz Composite video format
S-Video format
50 Hz Composite video format
S-Video format
Select either NTSC or PAL for use with the V-440HD. For
instructions on setting the SD signal format to be used, refer to
"Switching Between NTSC and PAL" (p. 49).
29