Sd Size4:3 Output - Edirol V-440HD Owner's Manual

SD Size4:3 Output

In shows and other situations where SD video is being output to LED displays or similar displays, you can output video from the V-
440HD's HD OUT connectors.
* Only the resulting composite video from the SD section is output from the V-440HD's SD PGM OUT connectors.
V-440HD Settings Parameters
Set the following parameters from the menu. Make parameter settings suited for the particular usage environment.
Settings Parameter
1. HD/RGB Output
2. HD/RGB Input
13. System
* For more on the menus, refer to Menu Operations (p. 25).
Settings Parameters for Devices Other Than V-440HD
It may be necessary to set the following parameters for the connected LED display being used.
Settings Parameter
Output Device (e.g., LED display)
HD Video Output Device RGB Video Output Device
HD Camera PC or Other Device
Final Output (HD)
LED Display or Other Display
1. Output Format (1080i) Sw,
etc.
3. Pre Scaling Mode
4. Manual Pre Scaling
5. Scaling Type
1. System Frame Rate
Values
Set the input to "Component Input."
SD Video Output Device
DV Camera, Player, Etc.
Selects optimal format, e.g., 480/60p or 480/60i, for the
output device.
* When "1. System Frame Rate" below is set to 50-PAL,
this parameter can be set to 576/50p or 576/50i.
There are times when excess portions of the HD video
may be displayed. In such cases, set the "3. Pre Scaling
Mode" to Manual and adjust with the "4. Manual Pre
Scaling" parameter.
There may be instances where the aspect ratio of video
input with HD or RGB is not 4:3. If satisfactory results
cannot be obtained even when this is set to "Full Size,"
"Fixed Aspect: Letter," or "Fixed Aspect: Crop," select
"Manual" and make fine adjustments to the "6. Manual
X Scale" and "7. Manual Y Scale" parameters.
Select the format appropriate for the output device you
are using.
Settings and Parameters
Related Page
p. 26
p. 58
p. 27
p. 59
p. 49
p. 64
81