Edirol V-440HD Owner's Manual page 40

SD Section Operations
Adjusting the Position of the Sub-Screen (SD)
1.
Press the LOCK button (SD).
The LOCK button (SD) is turned off.
At this time, operation of the POSITION joystick (SD) is
enabled.
2.
Move the POSITION joystick (SD).
Adjust the placement of the sub-screen while viewing the
screen.
Adjusting the Size of the Sub-Screen (SD)
1.
Rotate the SIZE knob (SD).
Adjust the size of the sub-screen while viewing the screen.
P in P Settings Cleared When Power is Turned Off
Be sure to save the P in P effect position, size, panning, and
zoom settings using the procedure described in "Saving the P in
P Effect Settings (SD)" at the right side of this page. Turning off
the V-440HD's power without saving the P in P settings will
result in a loss of the settings.
P in P Position and Size Settings
The settings processed with the above procedure are stored to
the lit P in P PATTERN button and saved until the V-440HD is
turned off. Use of the settings that have been changed with the
procedure above after the power is turned off requires that the
settings be saved to the V-440HD.
For more detailed information, refer to "Saving the P in P Effect
Settings (SD)" at the right side of this page.
40
2 1
1
Saving the P in P Effect Settings
To use P in P effect settings the next time the V-440HD is turned on,
save the settings to the P in P PATTERN buttons (SD).
When a P in P PATTERN button (SD) is held down for at least two
seconds, the P in P settings are saved to that button. All of the P in P
PATTERN buttons (SD) flash when saving of the settings is
completed.
Any settings previously stored to a P in P PATTERN button (SD) are
overwritten when new settings are saved to that button.
* To call up saved settings, press the P in P PATTERN button to which
the settings are saved.
Advanced P in P Effect Settings (SD)
Make the P in P effect settings from the menu with the "8. SD P in P"
parameters. Select the P in P PATTERN button (SD) to which the
settings are assigned with "P in P 1" to "P in P 5." Settings can be
made for the following parameters.
8. SD P in P Settings Parameters
PinP Size P in P size
PinP X Position Horizontal position
PinP Y Position Vertical position
PinP Border Size Border width
PinP Border Color Border color
PinP Trimming Width of portion trimmed from P in P edge
PinP Reset Resets the above settings to the original factory
settings
* For more on the menus, refer to "Menu Operations" (p. 25).
* You can quickly access the menu's P in P parameters by holding down
the MENU button and pressing a P in P PATTERN button (SD).