Basic Operation; Turning On The Power; Turning Off The Power; Outputting And Stopping The Final Output - Edirol V-440HD Owner's Manual

Basic Operation

Turning On the Power

941
• Once the connections have been completed (p. 20), turn on
power to your various devices in the order specified. By turning
on devices in the wrong order, you risk causing malfunction
TV monitors
and/or damage to
942
• This unit is equipped with a protection circuit. A brief interval
(a few seconds) after power up is required before the unit will
operate normally.
1.
Before turning on the power, confirm that all other devices
are properly connected.
2.
Switch the POWER switch on the V-440HD's rear panel to
ON.

Turning Off the Power

1.
Switch the POWER switch on the V-440HD's rear panel to
OFF.
945
If you need to turn off the power completely, first turn off the
POWER switch, then unplug the power cord from the power outlet.
Refer to
"Making the Connections"
and other devices.
(p. 20).
Outputting and Stopping
the Final Output
To output and stop the V-440HD's final output, use the OUTPUT
FADE button. You can have the final output fade out over the period
set with the TIME knob by pressing the OUTPUT FADE button. This
period can be set from 0.0 seconds to 4.0 seconds. Pressing the
OUTPUT FADE button after the final output has faded out causes
the video to fade in again.
If you are not going to fade the final output in or out, set the
TIME knob to 0.0.
TIME Knob
When the OUTPUT FADE button is pressed while a fade-out or
fade-in is in progress, the fade-out or fade-in stops at that point.
Pressing the OUTPUT FADE button once more starts the fade-
out or fade-in again.
Operation when the OUTPUT FADE
Button Is Pressed
If the OUTPUT FADE button is pressed a second time while the video
is fading, the output image will be switched as described below.
Response When OUTPUT FADE Button Is Pressed a Number of Times
(Figures shows operation with TRANSITION TIME set to 2.0 seconds)
Finish
When OUTPUT
FADE button is
pressed within
1.0 second
50%
1.0 sec
* You can set the operation mode of the OUTPUT FADE button. For more
details refer to "OUTPUT FADE Button Operational Mode" (p. 58).

Making the Fade-out Settings

The fade-out settings are made with "12. Output Fade Mode," "13.
Output Fade Color," and "15. Output Fade Sw Motion" under "1.
HD/RGB Output" in the menu (p. 24). For more details, refer to p. 58.
Output Fade Mode Sets the final output fade control
Output Fade Color Sets the final output fade color
Output Fade Sw Motion Fade-out operation setting
* For more on the menu, refer to "Menu Operations" (p. 25).
* You can move the cursor to the "12. Output Fade Mode" parameter
under "1. HD/RGB Output" in the menu by holding down the
MENU button and pressing the OUTPUT FADE button.
OUTPUT FADE Button
When OUTPUT
FADE button is
When OUTPUT
pressed
FADE button is
pressed more than
1.0 second later
Time elapsed
after pressing
button
2.0 sec
23