Sd Section P In P Effects - Edirol V-440HD Owner's Manual

Selecting the Bus Input
The video used on the A-BUS is selected by pressing the A-BUS
channel buttons (SD) 1-4. In the same manner, the video used on the
B-BUS is selected by pressing the B-BUS channel buttons (SD) 1-4.
When switching channels with the A-BUS channel buttons (SD)
and B-BUS channel buttons (SD), several frames is required to
switch the video in each bus. This is due to the time required to
lock the video signals when switching the video input formats
used in each channel. To shorten the duration, select the
following parameter from the menu and adjust the parameter.
* When you need to switch between Buses quickly, use the,
use Video Fader (SD) (p. 34)
* With some settings, noise may occur when the video is
switched. Set a value that provides sufficient time for
switching to avoid this problem.
• "13. System" - [10. SD Seamless Delay Time]
Keep the time setting somewhat short. The unit of time is
the field.
Customizing the Wipe
The wipe switching effects assigned to the TRANSITION (SD)
WIPE PATTERN 1-6 buttons can be set from the menu. You can
make settings for the wipe pattern, direction, and soft edge, and
combine these settings in various ways to create customized
wipe transitions.
* For more on the menus, refer to Menu Operations (p. 25).
* For more information about the different kinds of wipe patterns,
refer to "Customizing Wipe Transitions"(p. 29)
SD Section Operations

SD Section P in P Effects

P in P (Picture in Picture) effects are applied to the video on the A-
BUS or B-BUS. The P in P effect is used just by pressing the P in P
PATTERN buttons (SD).
Background Insert
Procedure for Setting the SD Section P in P Effect
1 3 2, 4
1.
Select the video to include in the sub-screen with the A-
BUS channel buttons (SD) (or B-BUS channel buttons (SD)).
2.
Tilt the video fader (SD) to the opposite side from that of the
bus selected in Step 1.
3.
Press a P in P PATTERN button (SD).
The button or buttons pressed in Step 1 flash. At this point, a button
flashing indicates that the P in P effect is being applied to the video
assigned to that button.
Button Sub-Screen Position (Factory Setting)
Upper left
1
Upper right
2
Lower right
3
Lower left
4
Center
5
4.
Tilt the video fader (SD) to the opposite direction.
The video assigned to the channels corresponding to the flashing
buttons in Step 3 appears as the sub-screen.
* When using the P in P effect while a key composite effect is in use, the
P in P is applied to the video with the key effect settings included.
* Use of the A-BUS channel buttons (SD) (or B-BUS channel buttons
(SD)) while combining video with the P in P effect may result in
disruption of the video image.
* Wipe Patterns 1-6 cannot be selected with the "TRANSITION
buttons (SD)" (p. 34) while the P in P effect is in use.
35