Basic Operation; Turning On The Power; Turning Off The Power; Outputting And Stopping The Final Output - Edirol V-440HD Owner's Manual

Basic Operation

Turning On the Power

941
• Once the connections have been completed (p. 20), turn on
power to your various devices in the order specified. By turning
on devices in the wrong order, you risk causing malfunction
and/or damage to speakers and other devices.
942
• This unit is equipped with a protection circuit. A brief interval
(a few seconds) after power up is required before the unit will
operate normally.
1.
Before turning on the power, confirm that all other devices
are properly connected.
2.
Switch the POWER switch on the V-440HD's rear panel to
ON.

Turning Off the Power

1.
Switch the POWER switch on the V-440HD's rear panel to
OFF.
945
If you need to turn off the power completely, first turn off the
POWER switch, then unplug the power cord from the power outlet.
Refer to
Making the Connections
(p. 20).
Outputting and Stopping
the Final Output
To output and stop the V-440HD's final output, use the OUTPUT
FADE button.
You can have the final output fade out over the period set with the
TIME knob by pressing the OUTPUT FADE button. This period can
be set from 0.0 seconds to 4.0 seconds. Pressing the OUTPUT FADE
button after the final output has faded out causes the video to fade in
again.
If you are not going to fade the final output in or out, set the
TIME knob to 0.0.
TIME Knob
When the OUTPUT FADE button is pressed while a fade-out or
fade-in is in progress, the fade-out or fade-in stops at that point.
Pressing the OUTPUT FADE button once more starts the fade-
out or fade-in again.

Making the Fade-out Settings

Make the fade-out settings with the "12. Output Fade Mode" and "13.
Output Fade Color " settings under "1. HD/RGB Output " in the
menu (p. 24).
Output Fade Mode Sets the final output fade control
Output Fade Color Sets the final output fade color
* For more on the menu, refer to "Menu Operations" (p. 25).
* You can move the cursor to the "12. Output Fade Mode" parameter
under "1. HD/RGB Output" in the menu by holding down the
MENU button and pressing the OUTPUT FADE button.
OUTPUT FADE Button
23