Table of Contents
Advertisement
To enter Cold Weather Mode (1-way remote):
1.
Rapidly press AUX twice. The remote's LED will start flashing.
2.
Press and hold
until the parking lights will flash for 2 seconds, pause, and then
flash 3 times.
To exit Cold Weather Mode, do any one of the following actions:
Open the hood.
Start the engine remotely.
Turn the ignition key to the IGNITION ON (RUN) position.
Press and release the AUX button.
a.
The
button on the transmitter will light up.
b.
While the
button is still lit, press and hold the
remote beeps once, pause, then beeps once again.
c.
Release the
button. Its LED will flash quickly.
(1-way remote) Rapidly press AUX twice. The re mote's LED will start flashing. Press
and hold
until the parking lights flash for 2 seconds, pause, and then flash twice.
To verify whether the system is in Cold Weather Mode:
(Automatic transmissions only) Press the brake pedal: If the vehicle is in Cold Weather
mode, the parking lights will remain ON while the brake pedal is pressed.
Do the vehicle status request feature (page-16).
Extended Run Time
While the vehicle is running under a remote start, press and hold the
beeps. This will reset the run time counter to zero and restart the run time cycle from the beginning.
Note: The extended run time procedure can only be carried out once per remote start.
To stop the vehicle, at any moment, simply press and release the
Example: If your remote car starter is programmed for a run time of 3 minutes and your vehicle
has been running for 2 minutes already, pressing the
and allow the engine to run for another cycle (in this case, 3 minutes).
Disable/Enable LED flashing
To disable the LED: Press
and
simultaneously until the remote beeps once, pauses for
2 seconds, then beeps once again. Release the buttons. The parking lights will flash 3 times.
To Enable the LED: Press
and
simultaneously until the remote beeps once, pauses for
2 seconds, then beeps once more. Release the buttons. The parking lights flash once.
Constant output
Pressing and holding the
button for more than 3 seconds will lock all doors and will send a
constant pulse as long as the
button is held down (maximum of 15 seconds). This constant
pulse can be configured to activate certain functionalities such as rolling up the windows – Please
refer to your installer to see if your vehicle is compatible with this option.
Pressing and holding the
button for more than 3 seconds will unlock all doors and will send a
constant pulse as long as the
button is held down (maximum of 15 seconds). This constant
pulse can be configured to activate certain functionalities such as rolling down the windows –
Please refer to your installer to see if your vehicle is compatible with this option.
User Guide
button until the
button until the remote
button.
button will reset the counter to zero
P.11
Advertisement
Table of Contents
