Telephone Operation; Analog Corded Lobby - A1100; Analog Corded 1-Line - A1210-A - VTech Analog Classic Series User Manual

Telephone operation

Analog Corded lobby - A1100

Receive a call
The telephone rings when there is an
incoming call. Lift the corded handset from the
telephone base to answer.
Place a call
Lift the corded handset and it automatically
connects to the operator. Refer to your
PABX user's manual for automatic dialling.
End a call
Place the corded handset in the telephone
base.
Volume
Listening volume and ringer volume can be
adjusted from the telephone base.
Adjust the listening volume
During a call, press +/- VOLUME to adjust
the listening volume. The next call returns to
the default listening volume.
Adjust the ringer volume
At any time, slide the RINGER VOL switch
on the right side of the telephone base to
adjust the ringer volume.
Data port
You can connect your modem or fax
machine to the telephone line through the
DATA port.

Analog Corded 1-line - A1210-A

Using the corded handset and the
telephone base
The corded handset and the telephone base
speakerphone cannot be used at the same
time. However, calls can be switched between
the corded handset and the telephone base
speakerphone.
Receive a call
The telephone rings and the MESSAGE
WAITING LED flashes when there is an
incoming call.
Answer a call using the corded handset
Lift the corded handset from the telephone
base.
Answer a call using the telephone base
On the telephone base, press
The /SPEAKER key illuminates when in
speakerphone mode.
Place a call
Lift the corded handset or press
SPEAKER on the telephone base. Listen for a
dial tone, and then dial the desired number, or
press a Speed Dial key to dial a programmed
number. The
when in speakerphone mode.
End a call
Place the corded handset in the telephone
base, or press
speakerphone mode.
EN - 37
/ SPEAKER.
/SPEAKER key illuminates
/ SPEAKER when in
/