VTech Analog Classic Series User Manual page 3

Analog corded lobby hotel phone,analog corded 1-line hotel phone, corded analog corded 2-line hotel phone ,analog corded trimstyle hotel phone,analog cordless 1-line hotel phone, analog cordless 2-line hotel phone, analog cordless charging base, analog co
Hide thumbs Also See for Analog Classic Series:
Table of Contents

Advertisement

• If the product has been dropped and the
telephone base and/or handset has been
damaged.
• If the product exhibits a distinct change
in performance.
15. Avoid using a telephone (other than
cordless) during an electrical storm. There
is a remote risk of electric shock from
lightning.
16. Do not use the telephone to report a gas
leak in the vicinity of the leak. Under certain
circumstances, a spark may be created when
the adapter is plugged into the power
outlet, or when the handset is replaced in
its cradle. This is a common event associated
with the closing of any electrical circuit. The
user should not plug the phone into a power
outlet, and should not put a charged handset
into the cradle, if the phone is located in
an environment containing concentrations
of flammable or flame-supporting gases,
unless there is adequate ventilation. A spark
in such an environment could create a fire
or explosion. Such environments might
include: medical use of oxygen without
adequate
ventilation;
(cleaning solvents; gasoline vapors; etc.); a
leak of natural gas; etc.
17. Only put the handset of your telephone
next to your ear when it is in normal talk
mode.
18. The power adapters are intended to be
correctly oriented in a vertical or floor mount
position. The prongs are not designed to
hold the plug in place if it is plugged into
a ceiling, under-the-table or cabinet outlet.
19. Use only the power cord and batteries
indicated in this manual. Do not dispose of
batteries in a fire. They may explode. Check
with local codes for possible special disposal
instructions.
industrial
gases
EN - 3
20. In wall mounting position, make sure to
mount the telephone base on the wall by
aligning the eyelets with the mounting studs
of the wall plate. Then slide the telephone
base down on both mounting studs until it
locks into place. Refer to the full instructions
in Installation in the user's manual.
CAUTIONS
• Keep small metallic objects such as pins
and staples away from the handset receiver.
• There may be a risk of explosion if a
wrong type of handset battery is used
(A1410, A1420, C3100 and C3200). Use
only the supplied rechargeable battery
(BT264392/BT266342)
battery (BT266342). Dispose of used batteries
according to the information in The RBRC®
seal in this user guide.
SAVE THESE INSTRUCTIONS
or
replacement

Advertisement

Table of Contents
loading

Table of Contents