VTech Analog Classic Series User Manual page 29

Handset registration
Place the cordless handset on the telephone
base cradle. Handset registration happens
automatically the first time a cordless handset is
placed on the telephone base.
When the registration process completes, the
MESSAGE WAITING LED flashes once and you
hear 3 rising beeps as confirmation.
Each telephone base accommodates up to
4 cordless handsets. When you already have
4 registered handsets, you can replace one
of them by a new handset if any one of the
4 registered handsets is disconnected from
the base. For example, it is out of range, or its
battery is removed or depleted. The previous
registered handset is then deregistered from
the telephone base.
Handset deregistration
When a registered cordless handset is idle,
press *331734# and then press HOLD. You
hear 3 rising beeps as confirmation when the
deregistration process completes.
Register a handset to another
telephone base
Any analog cordless 1-line handset can register
to any analog cordless 1-line telephone base.
Any analog cordless 2-line handset can register
to any analog cordless 2-line telephone base.
When a registered cordless handset is idle,
place it on another telephone base. This
cordless handset automatically registers to the
new telephone base.
Handset battery charging
The battery must be fully charged before
using the cordless handset for the first time.
The CHARGE LED turns on when the cordless
handset is charging on the telephone base
or charging base. The battery is fully charged
after 16 hours of continuous charging. For best
performance, keep the cordless handset in the
telephone base or charging base when not in
use.
EN - 29