Table of Contents
Advertisement
3. Function Display: To show the various menus and the selected functions
4. Button:
MENU
DOWN
UP
ENTER
5. POWER OUT: Water proof connectors for power output
6. DMX OUT:
Water proof connectors for DMX512 operation, use 3-pin XLR cable to output DMX signal
3.2 Main Functions
To select any functions, press the MENU button until the required one is shown on the display.
Select the function by the ENTER button and the display will blink. Use the DOWN/UP button to
change the mode. Once the required mode has been selected, press the ENTER button to setup or it
will automatically return to the main functions without any change after idling 7 seconds. Back to
the functions without any change press the MENU button.
The main functions are shown below:
Once you set
without any change or restarting the unit, the key board become locked. Press the
ENTER button to enable the menu, the display will show
UP/DOWN button until it shows
To select the programming functions
To go forward in the selected functions
To go backward in the selected functions
To confirm the selected functions
to
, after running in show mode for 5 minutes
, then press the ENTER to unlock.
6D
, press the
Advertisement
Table of Contents
