Address Setting; Dmx512 Configurations - ACME TOUR PIXEL BAR 1010 II User Manual

4.2 Address Setting

Use universal DMX controller to control the units, you have to set DMX address from 1 to 512
channels so that the units can receive DMX signal.
Press the MENU button, and the
change the DMX512 address. Once the address has been selected, press and keep ENTER button
pressed up to when the display stops blinking or storing automatically 7 seconds later. To go back to
the functions without any change press the MENU button again.
Please refer to the following diagram to address your DMX512 channel for the first 4 units.

4.3 DMX512 Configurations

Please refer to below configurations to control the fixtures
Attentions:
1. The unit will maintain the last condition until reset if you cut-off the DMX signal.
2. For the channel Function, keep the value for about 3 seconds, then the corresponding function
will take into effect.
4 Channels Mode:
CHANNEL
1
2
3
4
VALUE
000-255
000-255
000-255
000-255
will blink on the display. Use the DOWN/UP button to
FUNCTION
0%100%
0%100%
0%100%
0%100%
13D
RED
GREEN
BLUE
WHITE