Nomenclature - WEG ADW300 User Manual

General Information
The main components of the ADW300 are shown below:
Connection
of the inverter
power supply
Ground
Line 1 ~ 110 / 127 V
Neutral
or 220 V selectable
Phase
Line
Product power
110 - 127 V
supply selector
or
(2)
switch
220 V
DANGER!
(1) The MMF accessory, used to copy parameters, can only be connected to and
used with the ADW300 disconnected from the power supply.
(2) Before connecting the ADW300 to the power supply, make sure the 110 V /
220 V voltage selector switch is in the correct position.
The connection of any accessories must be done with the ADW300 disconnected
from the power supply.
Failure to comply with those recommendations will damage the product.
DANGER!
Do not touch the ADW300 while it is energized.
Any connection to or interaction with the product must be performed with the
product disconnected from the power supply.
Failure to comply with those instruction will cause risk of death.

2.3 NOMENCLATURE

Product
and
Frame Size
Series
Ex.: ADW300 A
A
03P5 = 3.5 A
06P0 = 6.0 A
ADW300
S = single-phase power supply
3 = 110...127 or 200...240 V selectable
00 = IP00
4 | ADW300
Status Error/Fault
indication
H1
PE
N/L2
L/L1
Figure 2.1: Main components of the ADW300
Table 2.1: Nomenclature of the ADW300 inverters
Model Identification
Rated Phase
Current Number
03P5 S
03P5 S
06P0
Connection of
the MMF flash
indication memory module
(1)
MMF
H2
MOTOR
U V W PE
M
3~
Connection of the
three-phase motor
Degree of
Rated
Protection
Voltage
3 00
3 00
5 V
Connection of
0 V
the digital inputs
DI4
(connect to the
DI3
conveyor belt
DI2
panel)
DI1
Hardware Software
Version Version
- -
Blank =
standard
Sx =
special
software
Blank = standard
Hx = special hardware