Installation Of Software; Setting Up The Hardware - SA Instruments 1030 Operation Manual

Installation of software

If the system was supplied with a PC, the software will already be installed. To start the
monitoring system double click the PC-sam icon on the desktop (refer to Chapter 3). To
view and format trend data click the TrendMap icon on the desktop (refer to Chapter 7).
To view saved SnapShot data files click the PC-sam icon on the desktop and select the
SnapView option.
If the system was not supplied with a PC, install the software following the instructions
on the inside cover of the CD. Specification requirements for the PC are listed in
Appendix A. If a USB port is being used to communicate between the PC and ERT
Control/Gating Module, use the appropriate driver from the USB Serial Converter CD
supplied with the system.
Windows can go to sleep and be difficult to awaken. Follow these instructions to disable
hibernation on your PC:
Windows XP: click Start>Settings>Control Panel>Power Options and open the
hibernate tab. Clear the hibernate check box.
Windows Vista or seven: click Start>Control Panel>Power Options and select
"Power Management Off".

Setting up the hardware

The Model 1030 has several optional functions. This manual assumes all functions are
present with the system. Ignore those sections of the manual for options not present
with your system. Refer to Appendix B for a list of major system components and
accessories. Refer to Chapters 10 through 14 for instructions on setting up and testing
the following options:
Pressure, Capnograph and Ventilator. Refer to Chapter 19 for instructions for the Water
Bed Heater System.
1. Locate the two simplex fiber optic cables (25SFOC-23) and fan air hose (FAH-
20), which is the longer of two heater hoses. If the MR scanner has a RF room, it
will be necessary to install the fiber optic cables and air hose passing through
wave guides.
plugs to gray receptacles and blue plugs to blue receptacles. Note: the simplex
fiber for the ERT Module will have a gray plug near the magnet while the fiber for
the Heater Module will have a blue plug near the magnet.
IBP, Pulse Oximetry, Fiber Optic Temperature, Fiber Optic
Follow the color code on the fiber optic cables connecting gray
Revision C, August 2013
Chapter 2
System Setup
2-1