System Fan Replacement - Western Digital Ultrastar Serv60+8 User Manual

User Guide
e) Slide the retention clip forward until it stops near the cable connector. Doing this will ensure that the
retention clip functions properly in the event the cable is pulled on for some reason.
Figure 46: Cinching Cable Retention Clip
8. Make sure the CMA is in operational position by folding the arm in toward the enclosure and attaching the
elbow end of the CMA to the connector that is attached to the rail. Verify that all of the cabling is in functional
order and does not bind or catch.

4.4 System Fan Replacement

Table 34: Replacement Procedure Info
Required Tools
None
1. Grasp both handles at the front of the enclosure and pull with even pressure to extend the chassis out of
the rack until it is stopped by the safety latches. The safety latches will prevent the enclosure from coming
out of the rack completely and the cover will remain in the rack attached to the rear alignment brackets.
Figure 47: Chassis Handle Operation
2. Locate the faulty System Fan by the flashing amber LED near the rear of the drive bay and the center
channel that will be lit on top if there is a fault or by activating the identify LED on the System Fan being
replaced.
3. Remove the new System Fan from its packaging.
# of People Required
1
61
4.4
Time Required
60s
4 Part Replacement
System Fan Replacement
Replacement Window
5 Minutes