Windows Upgrade To New Firmware - Western Digital Ultrastar Serv60+8 User Manual

User Guide
d) Locate the IP addresses in the Enclosure Services Controller Electronics (ESCE) elements, indicated
by the XXX.XXX.XXX.XXX in the results as shown in the following example:
Element type: Enclosure services controller electronics, subenclosure id: 0 [ti=5]
Overall descriptor: <empty>
Element 0 descriptor: ESCE IOMA,IOM PART NUM ,IOM SERIAL
NUM,5000CCAB0500003C,XXX.XXX.XXX.XXX
Element 1 descriptor: ESCE IOMB,IOM PART NUM ,IOM SERIAL
NUM,5000CCAB0500007C,XXX.XXX.XXX.XXX
5.1.6

Windows Upgrade to New Firmware

To download the new firmware package, do the following:
1. Input the sg_scan -s command to find the IOM devices to ensure that they can be accessed.
Note: If the Ultrastar Serv60+8 is connected to an HBA that does not present the Enclosure Services
Processor to the host for management purposes, HGST recommends attaching the Ultrastar
Serv60+8 to a host that does expose the Enclosure Services Processor so that the upgrade may
be performed.
2. In the terminal, type:
sg_ses_microcode SCSIX:X,X,X -m 0xe -N -b 4096 -I <filename> -vv
3. Press Enter.
The firmware begins loading onto the IOM. The upgrade can take up to 20 minutes to complete.
Important: Due to the firmware image being a .tar.gz file, the enclosure has to unpack and load
the firmware onto the respective ICs which may take up to 15 minutes. Once the sg_ses_microcode
command is issued wait 20 minutes to ensure the enclosure has time to perform this process. To
check the status of this process, use the Redfish out-of-band management to make a GET request
to the following target:
curl -G
address>/redfish/v1/UpdateService/Actions/UpdateService.SimpleUpdate/Status
Attention: If the OOBM is not being used, query Page Eh by executing the following command
sg_ses <device> -p0xe. The first time this command is issued, the output may be inaccurate,
please ignore and issue the command again. The string to observe for download microcode status
is "Complete, no error, start after hard reset or power cycle [0x11]" before proceeding to the activate
step.
Example output:
sg_ses /dev/sg0 -p 0xe
HGST
-k -u admin:admin -H "Content-type: application/json" https://<ip
H4102-J 2020
283
5 System Management
5.1 Storage Subsystem Firmware Upgrade