Upgrading Firmware With Oobm - Western Digital Ultrastar Serv60+8 User Manual

User Guide
Example output:
sg_ses /dev/sg0 -p 0xe
HGST
Download microcode status diagnostic page:
number of secondary subenclosures: 0
generation code: 0x0
subenclosure identifier: 0 [primary]
power cycle [0x11]
3. Issue the following command to activate IOM A:
sg_ses SCSI<dev> -p4 -c -d 02,00,01,00
5.1.8

Upgrading Firmware with OOBM

The following procedure should be followed to upgrade the firmware of the Ultrastar Serv60+8 using the
OOBM API.
1. Visit the HGST Support portal at
firmware package for the Ultrastar Serv60+8.
2. Extract the downloaded zip file and place file in a location that is accessible to the Ultrastar Serv60+8.
3. Make a POST call to the UpdateService object using the SimpleUpdate action. In the body of the POST
the ImageURI as the data parameter and set the value of this parameter to the file location of the bin file.
POST /redfish/v1/UpdateService/Actions/UpdateService.SimpleUpdate HTTP/1.1
Content-Type: application/json;charset=utf-8
Content-Length: <computed length>
OData-Version: 4.0
Authorization: Basic userid:password
{
"ImageURI": "tftp://<users IP Address>/"
}
Note: TFTP or HTTPS are
supported.
4. To check the status of this process, make a GET request to the following target:
H4102-J 2020
download microcode status: Complete, no error, start after hard reset or
download microcode additional status: 0x0
download microcode maximum size: 1703914 bytes
download microcode expected buffer id: 0x0
download microcode expected buffer id offset: 0
http://www.hgst.com/support/platforms-support
285
5 System Management
5.1 Storage Subsystem Firmware Upgrade
and download the