Rails Replacement - Western Digital Ultrastar Serv60+8 User Manual

User Guide

4.13 Rails Replacement

Table 43: Procedure Info
Required Tools
• Long T15 Torx Screwdriver
• # 2 Philips Screwdriver
• Long T10 Torx Screwdriver
• Cable Ties (for
configurations with greater
than 10 total cables)
• Tape Measure
• Level
1. Place the CMA into service position.
a) Unlatch the CMA at the elbow connector by pressing the blue release button to unlatch the connector
from the rail.
Figure 249: Unlatching a CMA Connector
b) Swing the CMA away from the enclosure.
Required Parts
• Reuse: M5 x 10mm T15
Torx screws
• Reuse:Included Washers
• Low-Profile M4 x 3.2mm
Philips screws (included
with rail assembly)
• Optional (if using CMA
Tray): M3 x 8mm T10 Torx
screws
201
4 Part Replacement
4.13 Rails Replacement
# of People Time
Required Required
3 Total (2 for ~1h
Team Lifting
Purposes and 1
to Guide and
Spot)