Table of Contents
Advertisement
Adaptec RAID Installation Guide
22
If you system contains multiple Adaptec RAID controllers,
repeat Steps
should ask you to reboot when this action is completed.
23
The Device Manager should now show an Adaptec I
Host Adapter in the SCSI and RAID Controllers section.
24
Optional: Using a text editor, remove the following entries from
your
config.sys
device=i2oddl.sys
device=dptcdrom.sys
25
Optional: Using a text editor, remove the
your
autoexec.bat
procedure, these
longer be needed.
Adding the Controller to an Existing Windows 95/98/Me
System
In this scenario, you are adding an Adaptec RAID controller to an
existing Windows 95/98/Me system. To install the driver
1
Install and configure your Adaptec RAID controller and hard
drives according to the instructions in
2
Start up the system. During startup, press Ctrl+A to start
SMOR. Use SMOR to create the RAID. For details, refer to
Using SMOR on page
3
Restart the system.
4
If Windows prompts for a driver to support a PCI card, go to
Step
11.
3-16
14
through
21
for each controller. The system
file:
file. When you complete the installation
and
config.sys
2-10.
mscdex
file entries may no
autoexec.bat
Chapter
O RAID
2
entry from
2.
Advertisement
Table of Contents
