Creating A User-Defined Fir Filter Using The Fir Table Editor - Keysight Technologies N5166B CXG User Manual
Signal generators
Hide thumbs
Also See for N5166B CXG:
- Service manual (451 pages) ,
- Programming manual (398 pages) ,
- Getting started manual (61 pages)
Table of Contents
Advertisement
Using Finite Impulse Response (FIR) Filters in the Dual ARB Real-Time Modulation Filter
Creating a User–Defined FIR Filter Using the FIR Table Editor
In this procedure, you use the FIR Values table editor to create and store an 8–symbol, windowed
sync function filter with an oversample ratio of 4.
Accessing the Table Editor
1. Press Preset.
2. Press Mode > Dual ARB > Arb Setup > More > Real-Time Modulation Filter > Select > Nyquist.
3. Press Define User FIR.
4. Press More 1 of 2 > Delete All Rows > Confirm Delete of All Rows.
This will initialize the table editor as shown in
Figure 9-18 Creating a User–Defined FIR Filter Using the FIR Filter Table Editor
Mode > Dual ARB > Arb Setup > More > Real-Time Modulation Filter >
Define User FIR > More 1 of 2 > Delete All Rows > Confirm Delete of
All Rows
Note:
Modulation filters must be real and have an oversample ratio (OSR) of 2 or greater.
Equalization filers are typically complex and must have an oversample ratio (OSR) of 1.
Entering the Coefficient Values
1. Press the Return softkey to get to the first page of the table editor.
2. Use the cursor to highlight the Value field for coefficient 0.
3. Use the numeric keypad to type the first value (−0.000076) from
numeric keys, the numbers are displayed in the active entry area. (If you make a mistake, you
can correct it using the backspace key.)
Keysight CXG, EXG, and MXG X-Series Signal Generators User's Guide
Basic Digital Operation (Option 653/655/656/657)
Figure
9-18.
For details on each key, use key help as described on
Active only when:
FIR filter coefficient table
has minimum of two
values visible.
page 60
.
Opens a menu that
enables you to select
and load a saved file
into volatile memory.
page 280
Adds a column for specifying the
imaginary coefficients of the filter.*
(All of the imaginary coefficients
will be 0 initially.) If the Convert to
Complex Filter softkey has been
selected the Convert to Real Filter
softkey becomes available.
Caution: Selecting the Convert to
Real Filter softkey removes the
Imaginary Values column and the
imaginary values are lost.
Table
4. As you press the
275
Advertisement
Table of Contents
