Controls - OREC RABBIT RM60W Instruction Manual

E S
NGINE WITCH
Insert ignition key to select start(
T
HROTTLE LEVER
Use throttole lever to adjust engine rpm between MAX and MINI.
C
HOKE LEVER
Use choke lever when it is cold to start engine.
Pull to close the choke(
There is no need to use choke lever when engine is warm enough.
H
EIGHT OF CUT LEVER
Height of cut is adjustable between 50mm and 100mm.
Press the lock bottun, select the height and release the finger from lock
bottun. Height of cut is indicated on the label near the lever.
Engine is stated only when this lever is in transport position.
CAUTION
Push the lock botton completely while height of cut lever is adjusted. If not,
machine may be damaged. For your safety, select the transport position
when machine enter/exit the field and also when going reverse.
BLADE CLUTCH LEVER
Use the blade clutch lever to switch the blade rotation ON(
Blade clutch lever cannot be activated when height of cut lever is in transport
position.
D
IFFERENTIAL LOCK LEVER
Normally operate the machine with differential lock lever in OFF position.
Shift the differential lock lever to ON in case of light slope, soft ground, or
when single rear wheel slips too much to go straight. It is also recommended
to shift the differential lock lever to ON when machine is loaded/unloaded
to/from the track.
CAUTION
The diff lock shoud be used only in straight line : never use the diff lock
lever when turning. The damage to the transmission will not be covered by
the warranty
S
PEED LEVER
Use the speed ever when driving, stopping, turning, and adjusting the speed.
A
UTO CRUISE LEVER
Use the auto cruise lever to fix the driving speed. While auto cruise lever is in "
does not return to neutral position(except reverse speed).
Remember to activate the auto cruise only when machine is stopped. Auto cruise is cancelled when brake pedal
is pressed, then speed control lever returns to neutral position.
OREC RM60W

CONTROLS

), ON(I), and Stop(O).
), and push to open(
Lock button
).
) or OFF( ).
8
Height guideline
Speed lever
R
F
" position, speed control lever