OREC RABBIT RM60W Instruction Manual page 29

O
FFSET PULL WIRE ADJUSTMENT
Offset open/close lever
Lock nut
A
T
IRE PRESSURE ADJUSTMENT
Front wheel
Rear wheel
CAUTION
Pay attention to equal the pressure of R & L tires. If not, handle control may be lost during operation.
F
RONT TIRE INSPECTION
CAUTION
Do not forget to remove the soil or grass which comes into tires. If they remain around the tire for a long time, tire
wheel, oil seal or bearing on the front wheel may be damaged.
Remove the mud and grass inside the tire wheel.
OREC RM60W
1)
fully toward operator(=offset at fully closed position).
2)
just nut. Take same way for both right and left side.
In order to close the offset,
-Move the adjust nut toward A.
In order to open the offset,
-Move the adjust nut toward B.
3)
Adjust nut
B
Refer to table below to check the pressure of tires.
Tire size
3.50-7
16x7.00-8
Refer to figure(left), and fix the offset open/close lever
Loosen the lock nut of offset pull wire and adjust with ad-
After this adjustment, securely tighten the lock nut.
29
Pressure(kPa)
120
140