OREC RABBIT RM60W Instruction Manual page 30

B ,
LADE INSPECTION REPLACEMENT AND SETTING
For safety, inspect the blades before the use.
This machine is equipped with sharp blades. Wear protective glove for blade inspection and replacement,
1)
and never tough the blades by hand. It may cause injury.
For blade replacement, use only genuine parts recommended by manufacturer. Manufacturer is not respon-
2)
sible for the trouble and accident with non-genuine parts, and it is not covered by warranty.
3) In case of impact caused by hitting the stone block or stumps, stop the use and check if blade or blade disc
is bent, cracked or damaged. Replace them if necessary. Before each use, make sure if damaged parts in
previous use are properly repaired or adjusted.
Blades rotate in very high speed. Even with small lack of part or small bend, it leads to big vibration. To
4)
continue operation with big vibration is dangerous and can be cause of clack on each part of machine. Ma-
chine's service life may be much shorter in this case.
Leaving the wear, bend, and lack of blades without maintenance may lead to serious accident such as thrown
5)
object of broken blade, or to damage of machine itself.
Blades must be replaced at full set at same time. Replacing only the particular blade may cause vibration.
6)
Ask skilled person with proper tool to replace the blades.
1)
Bag nut is consumable parts. In case of sharpening the blades, replace the bag nut to new one. Do not
2)
replace with other type of nut.
B
LADE INSPECTION AND REPLACEMENT
Blades are phasing
in 90 degrees
Left-
hand
screw
Cutter unit(R)
New
TIP :
When the machine is used in a place with sand or dry soil, blades can wear in shorter time. Check them
1)
frequently.
It is recommended to stock the spare blades to prepare for replacement.
2)
B
LADE SETTING
Pay attention to following instruction for blade setting.
CAUTION
In each blade replacement, bolts and nuts must be replaced to new one.
1)
Blade rotates left on cutter unit(L) and rotates right in cutter unit(R). Therefore, on M12 bag nut on cutter
2)
unit(R), left-hand screw is used to avoid loosening. And on M12 bag nut on cutter unit(L), right-hand screw
is used in same reason.
Pay special attention on desorption or replacement of knife neck guard.
3)
OREC RM60W
Stop the engine and remove key from engine switch.
Remove blade covers in right and left.
Inspect the clack, bend and wear on free blade disc.
Right-
Inspect the fixing status of nut on free blade disc.
hand
screw
In case blades are in following condition, change the blades be-
tween up and down or replace them to one.
Cutter unit(L)
Change up and down
worn
WARNING
CAUTION
Replace to new
Partly lost
30
bent