OREC RABBIT RM60W Instruction Manual page 9

P
ARKING BRAKE PEDAL
In case of emergency, when parking brake pedal is pressed, brake is activated
to stop the machine and speed control lever returns to N position. Normally use
the speed control lever to stop the machine.
While brake pedal is pressed, it is possible to use brake stopper to lock the
parking brake. Parking brake is cancelled when brake pedal is further pressed.
Engine is started only when parking brake is pressed.
B
LADE COVER
It is possible to remove this cover in case of blade inspection or maintenance.
Normally operate the machine with this cover fixed.
WARNING
It is very dangerous to cut grass without blade cover because a lot of thrown
ojbect is expected. Except blade inspection or maintenance, make sure that
blade cover is properly fixed.
S ( )
EAT SEAT SLIDE
Seat slide is adjustable. Loosen the 2x knob bolt behind the seat, and slide the
seat as needed. Pay attention to securely tighten the knob bolt in order to avoid
unexpected movement during operation. After the engine is started, when
operator leave the seat, engine is stopped for safety(engien switch remains "I").
CAUTION
Switch off the engine switch when engine is stopped. Or start the engine again.
If engine is left stopped, battery power may be lowered.
D
RIVING CLUTCH LEVER
Normally operate the machine with this lever in ON position.
In case of low battery or transport in a closed room, it is not good to start engine, therefore shift the driving clutch
lever to OFF to manually push the machine.
FU
SE BOX
Fuse box protect harness and electrical components in case of over current. It contains 10A(accessory),
20A(charge) and another 20A(spare). When fuse is cut, solve the problem and replace with spare fuse. Spare
fuse is only for emergency use, and replace it with genuine fuse.
P ( )
ILOT LAMP GREEN
Pilot lamp is turned on when engine swtich is in "I" position.
H
OUR METER
Hour meter shows rough hours of use. Refer it for maintenance.
P
ARKING BRAKE LAMP
Parking brake lamp is turned on when parking brake is activated.
O /
FFSET OPEN CLOSE LEVER
It is possible to move the offset angle in 3 positions. When the lever is in MAX position, offset is fully open. When
the lever is in MINI position, offset is fully closed. Offset lever is located in both right and left. Right lever operates
offset R, and left lever operates offset L.
OREC RM60W
( )
RED
9
Brake stopper
Lock
Parking brake pedal
Knob bolt