Breakdowns And Solutions - OREC RABBIT RM60W Instruction Manual

Problem
Cut grass is not dis-
charged well.
Grass is not fully cut
Cut into the ground
Blade slips
Blade does not stop
in 5 seconds
There is big vibration
Mowing workload is
heavy
Tires are slipping.
Machine does not
stop with speed lever
in N position
Poor power to drive
the slope
Speed lever does not
move the machine
Parking brake does
not work well
* If you have any questions or do not understand any points, please contact your dealer.
OREC RM60W

BREAKDOWNS AND SOLUTIONS

Cause
Grass is wet.
Grass is tall.
Cutting height is too low.
Engine power is too low.
Mowing speed is too fast.
Mowing speed is too fast.
Engine power is too low.
Blade is blunt, worn out or broken.
Some grass is stuck inside of
rotary cover.
Grass is tall.
Mowing the pushed grass.
Cutting height is too low.
Turning speed is too fast.
The ground is wavy-shaped.
The ground is bumpy and has many
ups and downs.
Blade stay is bent or deformed.
Belt tension is not enough.
Obstacle remains inside blade cover
Grass remains on pulley
Belt is worn.
Blade brake shoe is worn.
Blade brake is poorly adjusted.
Blades are poorly balanced.
Blade is damaged.
Grass remains around knife neck
guard
Blade shaft is bent.
Blade belt is broken.
Blade stay is bent.
New and old blades are installed.
Engine power is too low.
Mowing speed is too fast.
Some grass is stuck on/around blade
shaft.
Grass is tall.
Cutting height is too low.
Differential lock is OFF.
Ground is soft.
N position is not properly adjusted.
Driving belt is not well tensioned.
HST oil is in short, degraded or
air/water is mixed.
HST oil is not enough.
HST hose is getting off or broken
Driving clutch lever is in OFF position. Move the driving clutch lever to ON position.
Brake shoe is worn.
Oil is coming into brake drum.
Water is coming into brake drum.
Tire is worn.
Wait until grass get dry.
Mow higher and cut twice.
Raise the cutting height.
Increase the power to the max.
Decrease the speed.
Decrease the speed.
Increase the power to the max.
Replace the blade with a new one.
Clean up and take out grass inside of the
cover.
Mow with higher cutting height first.
Mow against grass.
Raise the cutting height.
Turn slowly.
Change the direction of mowing.
Raise the cutting height.
Replace the blade to new one.
Adjust the belt tension.
Clean inside the blade cover.
Clean the pulley.
Replace the belt.
Replace the brake shoe.
Adjust the blade brake.
Replace all blades.
Replace the blade to new one.
Clean around the knife neck guard.
Replace the blade shaft.
Replace the belt to new one.
Replace the blade stay.
Do not install new and old blades together.
Increase the power to the max.
Decrease the speed.
Clean up the blade.
Mow with higher cutting height first.
Raise cutting height.
Move the differential lock lever to ON.
Wait until the ground get dry.
Adjust the turn buckle to modify N position.
Give more tension on the driving belt or re-
place the belt.
Add or replace the HST oil or remove the air.
Add HST oil.
Set the HST hose or replace it if it is damaged
Replace the brake shoe.
Remove the oil and replace the oil seal.
Press and release the brake and dry inside.
Replace the tire.
36
Solution