OREC RABBIT RM60W Instruction Manual page 24

Muffler
I
MACHINE NSPECTION AND ADJUSTMENT
CAUTION
1) Place the machine on flat and spacious area without obstacles before to realize inspection, maintenance and
adjustment. Do not forget to stop engine and remove key. Wait until engine is cool enough to start the work.
2) Check if all levers work properly(before every use).
3) Wire and belt get loose after the first period. Adjust them at every 2-3 hours.
4) Wire and belt are consumable goods. Replace them in case of abnormal condition.
5) Operate the machine for short time, and check if abnormal noise or temperature is found or not.
6) Check if each bolt and nut are properly fixed and in place. Tighten them if necessary.
7) In case covers are removed for adjustment, place them in original position.
8) Do not overwork during the first 2-3 hours in order to make each part in good condition.
9) Remember to realize maintenance after each use regular inspection.
10) Check the machine thoroughly to see if there is no oil leak in each part.
-If there is oil leak, contact your nearest dealer.
-To continue using with oil leak is dangerous and may lead to damage of machine.
W
IRE AND BELT ADJUSTMENT
CAUTION
Before to adjust belt, wire and rod, place the machine in a flat and spacious area and stop engine. To ensure
safety, lock the parking brake and remove key.
Seat bracket
OREC RM60W
Remove grass around the mullfer.
2)
Before to adjust the belt and blade brake, grip the points marked
1)
in arrow and pull them up to open the seat bracket upward. Seat re-
main fixed when seat bracket is maximum opened.
Remove the side covers to adjust wire and rod.
2)
Contact your nearest dealer to replace driving belt and blade belt.
3)
24