OREC RABBIT RM60W Instruction Manual page 15

L / /
OADING UNLOADING
DANGER
1) Stop the engine and close the fuel cock while transporting this machine. Otherwise, fuel may leak and may
cause fire accident.
2) Do not lean the machine more than necessary, because fuel may spill over.
WARNING
1) Always use the bridge for loading/unloading. In case of loading/unloading by hook, there is a risk of falling
and is very dangerous. Never use hook for loading/unloading.
2) Do not stop on the bridge. If the machine balance is heavier in the back, front of the machine may be lifted up
when driving is started again. Load/unload the machine only in slow speed.
3) Place the height of cut lever to transport position during loading/unloading. Otherwise blade may touch the
bridge and it may cause tipping over.
4) Keep the differential lock lever to ON, and do not move it on the bridge.
5) On the truck, keep the engine off and fuel cock closed, and remove the key. Fix the machine with rope/belt
which is strong enough.
L /
OADING UNLOADING
TIP :
Recommended bridge : Use only certified bridge, which is strong enough.
Length :
Width :
Strength :
M
OWING
OREC RM60W
TRANSPORTING
1)
2)
3)
position, and do not place into other positions.
to be more than 3.5 times longer than height of truck.
to be suitable for width of this machine.
to be strong enoguh against total weight of machine and operator.
1) Start the engine.
2) Move the throttle lever to MAX and increase engine rpm.
3) Place height of cut lever at 100mm.
4) Push down the blade clutch lever forward.
Move forward for loading and move backward for unloading.
Use the bridge certified in safety.
Place differential lock lever to ON, height od cut lever in transport
15