Inspection Before Use - OREC RABBIT RM60W Instruction Manual

Before each use of machine, refer to table below and realize the inspection.
Where to check
Engine Engine oil
Air cleaner
Machine Blade
Brake(if equiped)
Tire
Lever(s)
Cover(s)
HST oil(if equipped)
WARNING
Always make inspection, re-fueling, adjustment and maintenance only after engine is stopped. ]
1)
Make sure about position of each lever and safety around the machine, before to start engine and
2)
check the movement of levers.
Check and read the safety labels on the machine.
3)
ENGINE OIL INSPECTION
Oil cap
CAUTION
In case of checking engine oil after the work, wait more than 5 minutes to cool down the engine. Make sure
1)
if muffler and engine is cooled enough.
Shortage of excess of engine oil cause engine trouble. Check the engine oil before every use.
2)
Recommended engine oil type is 10W-30.
3)
After the engine oil is filled up, securely fix the oil gauge. If the fixing is loose, engine oil may leak.
4)
FUEL INSPECTION AND REFUELLING
Fuel gauge
OREC RM60W

INSPECTION BEFORE USE

LIST OF PRE-USE INSPECTION
Oil gauge
Upper limit
Lower limit
Place the machine on flat surface and remove fuel cap. Check
1)
Fuel cap
the level of fuel through fuel mouth.
2) In case fuel gauge is close to "E", it is necessary to refuel.
Check point
Quantity and dirt of oil
Dirt
(1) Looseness or loss of bolt
(2) Deformation, wear or contact
(3) Smooth movement or sticking
(4) Remove dust and grass
Quantity and dirt of oil
1)
surface and remove the oil gauge.
2)
as oil gauge. Wipe the oil gauge with
cloth and insert it to check the oil level.
If oil level is not between upper and
lower limit, add engine oil until the
level comes between upper and
lower limit.
10
Place the machine on flat
Edge of oil cap is designed