OREC RABBIT RM60W Instruction Manual page 31

Refer to figure(below) for setting up the 8 blades. If they are placed in wrong position, they hit each other
4)
while mowing and lead to loss, clack, damage and vibration of blades.
Securely tighten the bolt and nut after the blade setting.
5)
Turn the M10 bolt on free blade disc toward left and loosen it.
After free blade disc is removed, replace the blades.
Disassembling of the blades
Knife neck
guard
Tightening
torque(M12)
80Nm
O
FFSET BLADE REPLACEMENT
TIP :
Blade rotates left on cutter unit(L) and rotates right in cutter unit(R). Therefore, on M12 bag nut on cutter unit(R),
left-hand screw is used to avoid loosening. And on M12 bag nut on cutter unit(L), right-hand screw is used in
same reason.
Cutter unit(R)
Blade holder
Rotary
protector
OREC RM60W
Tightening
torque(M10)
54Nm
1)
from the rotary protector hole.
2)
Cutter unit(L)
tary protector.
3)
fix it. Pay attention to right-hand screw and left-hand screw.
Offset blade
M12
bag nut
View from side
*Make sure about upper side and lower side.
**It is possible to reuse the blade when turned upside
down.
Refer to figure(left). Use box wrench and remove nut
Set the offset blade on blade holder and fix them by ro-
Place the removed nut in original position and securely
31
Tightening
torque(M10)
50Nm