OREC RABBIT RM60W Instruction Manual page 35

E
NGINE TROUBLESHOOTING
In case of engine trouble, refer to table below and take proper countermeasure.
Problem
Starter does not Parking brake is not pressed.
work
Height of cut lever is not in transport
position.
Operator is not seated.
Safety switch is not in good
condition.
Battey is empty.
Battery cord is not connected.
Coupler wiring is not connected.
Magnet switch is not good.
Harness is cut or damaged
Battery is not Charge coil is not good.
charged
Fuse is broken.
Regulator is not good.
Battery is out of life.
Engine cannot Throttle lever is not in MINI position.
be started Choke lever is not in "start" or "cose"
position.
Fuel does not run.
Fuel filter is clogged.
Air or water is mixed in fuel running
system.
Oil is stickly in cold weather and
engine rotation is not smooth.
Ingintion coil or unit is not good.
Spark plug is not good.
Battery is empty.
Fuel quality is bad.
Fuel is not enoguh.
Power is poor Fuel is not enough.
Air cleaner is clogged.
Fuel quality is bad.
Choke is not fully open.
Cooling system is clogged.
Engine stops Fuel is not enough.
Fuel cock is closed.
Exhaust gas is Fuel quality is bad.
too black Air cleaner is clogged.
Black smoke Air cleaner element is clogged.
comes out and
Choke is not fully open.
power is lost
Blue-white Engine oil is too much.
smoke comes
Cylinder and piston ring is are worn
out from muffler
Engine rpm is Choke is not fully open.
not stable Fuel quality is bad.
Engine stops Ignition coil is not good.
later
Fuel filter is clogged.
Exhast gas Fuel quality is bad.
badly smells
OREC RM60W
Cause
35
Solution
Press parking brake pedal and lock it.
Move the lever to transport position.
Stay on the seat.
Adjsut the switch within 3-5mm allowance.
Charge the battery.
Connect the battery.
Connet the wiring.
Replace the magnet switch.
Replace the harness.
Repalce the charge coil.
Replace the fuse(charge : 20A)
Replace the regulator.
Replace the battery.
Move the throttle lever in MINI position.
Tighten the choke lever when engine is cooled.
Check the fuel tank and remove the sinking stuff and
water.
Place the fuel cock to "open".
Replace the fuel filter.
Remove the stuff, check the hose band, and replace
if necessary.
Select proper oil depending on weather.
Replace ignition coil or unit.
Check the gap between terminal and adjust.
Replace the spark plug.
Disconnect the battery when machine is not in use.
Keep battery fully charged and put it on machine
before use.
Replace to good quality fuel.
Add the fuel.
Add the fuel.
Clean the element.
Replace the fuel to new.
Push down the choke lever completely to open it.
Clearn around th screen guard.
Add the fuel.
Open the fuel cock.
Replace to good quality fuel.
Clean the element.
Clean the element.
Push down the choke lever completely to open it.
Reduce the engine oil to required level.
Replace the ring.
Push down the choke lever completely to open it.
Replace to good quality fuel.
Replace the ignition coil.
Replace the fuel filter.
Replace to good quality fuel.