Controls - OREC LS 280 Owner's Manual

Travel lever(A, figure1)
This lever transmits the power
from the engine to the
transmission. Grip the lever with
the handlebar and it will be in
"driving" position. Release the
handlebar and it will be in "stop"
position.
The driving clutch lever is
connected with the brake. When
the lever is in "stop" position, the
parking brake is led to "on"
condition.
Do not fix the driving clutch lever with wires or strings or straps, which is very dangerous.
Speed lever (F, figure1)
This lever decides the speed of the machine. There are two steps for driving forward ("1" & ''2") and one
step for driving backward ("R'). Before changing speed, shift the driving clutch lever to "stop" position and
stop the machine.
Only allowed to change travel speed when machine is stopped.
Side Clutch Lever (C, figure1)
It is to change directions of the machine. Grip either lever and the machine turns to that direction. When
you grip both levers at the same time, the machine stops on the spot.
Handle the side clutch lever with a low speed, or the machine will turn fast, which is very
dangerous.
ON/OFF engine switch (D, figure 1)
Turn the switch « ON » to start the engine. Turn the switch « OFF » to
stop the engine.
Dumping Lever (G, figure 1)
It is necessary when the platform is dumping. Grip the lever and pull it
up.
Choke lever (E figure 1)
Pull the choke knob to start the engine when it is cold. Push the knob
when the engine has started.
Throttle lever
(Figure 3)
It is to adjust the rotation of the engine.
© SAT – 09/2006

CONTROLS

WARNING
.
WARNING
WARNING
10
Figure 1
Figure 3
Ｇ